Fiat Punto ABS Light On Causes. A good code scanner will often tell you which part of the ABS system failed. Not every OBDII scanner will give up this information. A good one will. Most auto parts stores will have a free scanning service they would gladly let you utilize. Here are the five most common reasons the ABS Fiat Punto’s ABS light The fuse controlls all the dashboard lights - the others are working so it's not that. I can't see any damage on the circuit board on the back of the dash unit. Has anyone else had this fault or does any one have any ideas what else I can try. I'd like to fix it if I can because the break fluid light and break pad wear lights are all affected. If your still having no luck, then what you could do is get your multi- meter out and check that you have voltage at the light multi-plug for each of the functions. If you do then you know its a contact issue. if you do want to go down that route then post back and we will tell you which wires to test. Alan. 1. 2. So my full beam works, DRL are working, side lights and fog lights are working but the normal dipped headlights just aren't working. Working yesterday, got in the car today, turned them on and nothing. Not working. And it's BOTH?! Both lights stopped working? Any ideas? (Punto EVO GP 2010) We'll start with a dash light that isn't technically a warning light. The fog light symbol looks a lot like the one used for the regular headlights, albeit with a squiggly line in front of it A warning light on your Fiat Punto ‘s dashboard resembling a caterpillar or a long tube with flashing lines may be related to the heads-up display system. If no corresponding error message appears on the separate heads-up display unit, this could indicate a system malfunction. Surrey. Nov 25, 2015. #6. Mine has come back and this time the none of the rear passenger side lights are not working! Other side is fine except indicators fo mental when activated. Changed all the bulbs but didn't make a difference. Looked in the connector block and it appears the black wire has shorted or something as signs of heat and black 4. Pull the centre console away from the dash. (note the bit with your "city" button and fog light switches etc will still stay attached. As will the heater fan and blower position knobs, but everything else will pull away) Also, REMEMBER to disconnect the wires powering the cigarette lighter. They simply pull out. Revealing below: 5. Turn on POWERTRAIN DASHBOARD WARNING LIGHT This dashboard symbol may illuminate red or yellow / amber on the Ford Transit / Connect. A cog with an exclamation mark inside indicates a malfunction with the powertrain, a sensor or software fault. A malfunction with the powertrain may see the vehicle lose a certain amount of power, but will continue to run. vm7cuPI.

fiat punto dashboard lights not working